Skip to content

Driver support

Charging help, without the queue at reception.

If you are using an EV Smart charge point, this page covers the basics. If something has gone wrong, contact the support team with the unit number and we will look at it remotely.

Using a charge point

Five steps to a session.

  1. 01

    Park in a marked bay

    Bays are marked with the charging type and any access restrictions.

  2. 02

    Connect the cable

    Plug into the vehicle first, then follow the instructions on the charger screen.

  3. 03

    Choose your payment method

    Tap a contactless card, use the app, or present a registered RFID card.

  4. 04

    Start and monitor

    Charging begins once the vehicle and charger have completed the handshake.

  5. 05

    Stop and unplug

    End the session on the charger or in the app, then release the connector from the vehicle.

Payment options

  • Contactless debit or credit card at the charger
  • Mobile app for session control and history
  • Registered RFID card where one is issued
  • Roaming with partner networks where supported

Public charge points accept contactless bank cards where contactless payment equipment is fitted: the screen on the unit confirms the payment methods available there. Card details are handled by the payment provider and are never stored by EV Smart.

App and RFID

The EV Smart app lets you start a session, monitor charging and see your history. Registered RFID cards are supported where they have been issued.

About the EV Smart app

Charging speeds

Rapid units add significant range in 20 to 40 minutes. Slower AC bays are intended for longer stays. The speed shown on the charger reflects what your vehicle can accept, which is often lower than the charger's maximum.

Troubleshooting

The charger will not start a session

Check the connector is fully seated in the vehicle, then end the session on screen and try again. If the screen shows an unavailable status, the unit needs our attention: call the number on the charger.

The session stopped before the vehicle was ready

Some vehicles pause charging when the battery is full or very cold. If the charger reports a fault, note the unit number and time and contact support with your reference.

The connector will not release

Unlock the vehicle first, then press the release on the connector. If it remains locked, do not force it: call support and we will release it remotely where possible.

I was charged but no energy was delivered

Send us the time, the unit number and the last four digits of the card used. We will check the session record and refund any session that delivered no energy.